Lair Of The Multimedia Guru

2017-06-24

Stepper motor vibration damper lifetime

When i installed the vibration dampers a few months ago on my 3D printer. I wondered how long the metal to rubber connection would last. One or 2 days ago my extruder started to skip. After checking it and the hot-end for clogging, i found the vibration damper was no longer in good shape. about 50% of the rubber had separated from the metal.
Thus the lifetime of that one was about 2 months with low to moderate use.

Somewhat expecting this i already had a bag of replacements and replaced it. Lets see if this is a one time failure or if this repeats. Opening the arm of the extruder when not in use should reduce the stress on the part though. But until i see a repetition of this failure mode ill leave things as they are. So as to exclude that this is a one off faulty part.

Low cost 3D printers (in 2017) are “fun”, theres “always” something that needs adjusting or fixing.

Filed under: 3D printer — Michael @ 00:04

No Comments »

No comments yet.

RSS feed for comments on this post.

Leave a comment

Powered by WordPress