Lair Of The Multimedia Guru

September 9, 2018

3D printer particles / air pollution part2

When i experimented with measuring the amount of particles from my 3d printer, i noticed the majority originated from when the heat-bed was turned on. I had cleaned the inside of the printer roughly before, so this was slightly odd. More investigation shortly later revealed the cause though.

The use of tinned multi-core wire without ferrules. Why it was done this way you may ask? Because between the incomplete and poor official documentation, the consumer made videos of how to assemble it and my plain lack of knowledge about how multi-core wire with and without solder behaves in this case. This way of connecting the wires seemed sound enough and there also where no ferrules included with the printer kit.
That said if you did connect high current wires in a similar fashion, you probably want to consider redoing it with ferrules or in another reliable way, like directly soldering to the board or soldering a solid core wire onto the multi-core as an intermediate. Also keep in mind iam a programmer not a expert for this so do your own research if failure of a connection could have some real consequences.
My printer is fine, the heat-bed also didn’t behave erratically or anything. And i never trust/trusted it anyway in terms of safety to ever run it without someone being at home, so in my case it was impossible for this to cause any real harm. But i still didn’t expect that …

I didn’t had any fitting ferrules, so the way i fixed it was to take some terminal connector thingies, which when one cuts half of each off are basically ferrules. I also didn’t had a new terminal block that was rated for enough amps to replace the roasted one. I will properly replace these once i have proper replacement and have time. Quite likely next time that printer needs some kind of “service”.

Filed under: 3D printer,Electronics — Michael @ 17:09

Powered by WordPress